Monday 26 May 2014

steps of foundation of building

Survey and Stake
Before any construction can begin, the home site is surveyed to
establish the home's basic footprint and to ensure the home is set
back the appropriate distances from the property lines. The corners
of the home are marked by surveyor's stakes. Offset stakes, which
are about two feet out from the surveyor's stakes, also are placed.
The excavator will dig at the offset stakes, creating a slightly larger
hole than the foundation actually will occupy. The extra room
enables crews to work on the exterior of the foundation walls.
Excavation
The depth of the excavation is determined by a structural engineer
who considers the soil, the frost line and the height of the water
table (the depth in the soil at which you find water). Surface soil is
removed to expose soil that is compacted enough to bear the load of
the home. The excavation must be deep enough to place the top of
the footing below the frost line. This prevents the concrete from
cracking due to the freeze-thaw cycle of the surrounding soil. The
excavation cannot be so deep that it's below the water table,
however, because that can cause a chronically wet or flooded
basement.
Footings
Footings are poured concrete pathways that help to spread the
weight of the home from the foundation walls to the surrounding
soil. Footings are wider than the foundation walls they support, and
form the perimeter of the home. Sometimes, additional footings are
added inside the perimeter to support load-bearing interior walls.
Sub-slab Systems
Plumbing lines are run from the street to the home's basement, by
going under or over the footing. In some regions, soil gas mitigation
systems are added to collect the soil gases trapped under the slab
and vent them to the outside. Eventually, these systems will be
covered with the poured concrete slab that is the basement floor.
Foundation Drainage Tile System
This system collects subsurface water and moves it away from the
foundation. Foundation drainage tile consists of a continuous run of
perforated drainage pipes embedded in gravel along the outside
perimeter of the footings.
Some building codes require drainage pipes along the inside
perimeter of the footings as well.
Sump
In regions where the earth is flat or the soil tends to be wet, a sump
may be added to help collect subsurface water. A sump pump moves
the collected water away from the home.
Walls
Foundation walls are constructed by pouring concrete between sets
of form work (the total system of support assemblies for freshly
poured concrete, including mold, hardware and necessary bracing.)
Once the concrete gains its full strength, the form work is removed.
Foundation wall thickness is determined by a structural engineer
who considers the height of the wall and the load it has to bear.
(Structural load is the force or combination of forces of gravity,
wind, and earth that acts upon the structural system of a home).
Wall thickness varies from home to home, and even within a home.
Anchor Bolts
Anchor bolts are embedded at pre-determined points along the top
of the foundation walls. They'll be used during framing to secure the
framing to the foundation.
Beam Pockets
Beam pockets are cast in the top of the foundation walls to receive,
support, and hold beams in place.
Dampproofing and Waterproofing
A dampproofing or waterproofing seal is applied to the exterior of
the foundation walls that eventually will be below-ground. This
slows or stops water from traveling through the walls and into the
basement.
Slab
A 3-inch to 4-inch thick concrete slab is poured between the walls.
The slab helps to stabilize the base of the foundation walls, and
also forms the basement floor.
Backfill
Backfill is pushed into the trenches around the exterior of the
foundation walls, burying a portion or all of the walls below the
surface for added stability. Ideally, backfill is soil that drains easily.

No comments:

Post a Comment